Wappler Version : Wappler 2.6.5
Operating System : macOS Catalina 10.15.3
What do you think should happen?
After adding the File Upload… then adding Load Image, it should list the file’s attributes, i.e., file path, etc.
What actually happens?
The Load Image is missing the choice for the file path, etc.
What expression is selected in the file upload step?
I was reviewing an existing Action Steps when I noticed this anomaly. I selected the Load Image, and noticed that though the Expression still had {{upload_file.path}} in the Expression area.
However it’s missing where it is usually found. As seen in the previous image.
I was asking about the expression selected in the file upload step, not in the image load step.
Ok, so in the $_POST.photo properties under General is the type set to file?
Ok, thanks. We are going to check this.
Teo, do you think it is possible to just to manually type in the path until it is repaired? That is, type {{photo_upload.path}} in the Load Image Properties. Will this update the api file?
Yes, you can manually add this.
